Krautkramer DynaPOCKET Issue 03, 04/2005 3-9
Selecting instrument settings Operation
Material group
If you intend to carry out measurements on high-alloy
steels or on other materials, such as nonferrous met-
als, you must set the DynaPOCKET to the required
material.
Choose the appropriate material from the 9 material
groups stored in the DynaPOCKET.
Setting options:
St Low-alloy/unalloyed steel and cast steel
ASt Tool steel
SSt Corrosion-resistant steel
GCI Gray cast iron
NCI Nodular graphite cast iron
AL Aluminum cast alloys
brS Brass
brZ Bronze
Cu Wrought copper alloys
– Press the two keys simultaneously to select the
setup mode.
– Select the parameter MAt with the MODE/CLEAR
key.
– Press the ENTER/SET key to change the current
setting.
– Use the MODE/CLEAR key to confirm the selected
setting, and press the key again, if necessary, to go
to the measurement mode.
To Next Page
Loading...
