Krautkramer DynaPOCKET Issue 03, 04/2005 3-11
OperationSelecting instrument settings
Conversion
The DynaPOCKET provides verious conversion op-
tions. The conversions according to DIN 50150 and
ASTM E140 only apply to the material group St (steel
and cast steel) (please refer to overview of conversion
ranges in chapter 7.2).
Setting options:
dynA DynaPOCKET-specific
din DIN 50150
E140 ASTM E140
– Press the two keys simultaneously to select the
setup mode.
– Select the parameter Con with the MODE/CLEAR
key.
– Press the ENTER/SET key to change the current
setting.
– Use the MODE/CLEAR key to confirm the selected
setting, and press the key again, if necessary, to go
to the measurement mode.
To Next Page
Loading...
