Kreg ADAPTIVE CUTTING SYSTEM - Page 13

SETUP
(3) Position the track on a table with the front
 endandtheanti-chipstripedgeofthe
 trackextendingslightlypasttheend
 andedgeofthetable.Placethesawon
the track with the front of the saw
 overhangingtheendofthetrack
 enoughtoallowaccesstothe
 fronttoe-inadjustmentscrews.
(5)Plungethesawtotheblade-change
 position.(SeeChangingthebladeinthe
 followingsection.)Adjustthesawsoa
 saw-bladetoothcontactstheanti-chip
strip at the front of the blade.
(6)Tightenthefronttoe-inadjustmentscrew
closest to the blade to hold it in position.
5
6
3
4
4
(4)Loosentoe-inadjustmentscrewsjust
 enoughtoallowside-to-sidemovement
of the blade.