Kreg ADAPTIVE CUTTING SYSTEM - Setup: Finalize Toe-In Adjustment

SETUP
(8) Insert a business card or construction
paper approximately 0.010" thick between
 abladetoothandtheanti-chipstripatthe
 rearoftheblade.Thissetstheproper
 bladetoe-in.
(9)Tightenbothreartoe-inadjustment
screws. Remove saw from the track and
 tightenthesecondfronttoe-inadjustment
 screw.Verifyallfourtoe-inadjustment
 screwsaretight.
8
9
9
(7) Reposition the track so the rear end and
 anti-chipstripedgeofthetrackextends
 slightlypasttheendandedgeofthetable.
Slide the saw back to the rear of the track
 withtherearofthesawoverhangingthe
 endofthetrackenoughtoallowaccess
 tothereartoe-inadjustmentscrews.
7