4
Assembly
1
Assemble Depth Bar to Cross Bar
a. Using the supplied Hex Wrench (1) and Socket Head Cap Screws (H), align and attach the
Depth Bar (A) with Cross Bar (B) with measurement markings both facing up, making sure
that the zero marks align. See below for proper attachment.
b. Slide Adjustable Drill Guides (E) onto each side of the Cross Bar (B).
c. Slide End Stop (D) onto Cross Bar (B) on the left side.
d. Slide Alignment Stop (C) onto Depth Bar (A).
C
H
E
E
B
D
A
1
Attention Tighten the Socket Head Cap Screws (H) using the Hex Wrench (1) until the screws
are snug and then apply a 1/4 turn to nish tightening. Do not over tighten as this can damage
the Depth Bar (A) rendering it inoperable. In the event of overtightening, contact Kreg Customer
Experience.
To Next Page
Loading...
