How to prevent chip out when using Kreg PRS1000?
To minimize chip out when using Kreg Tools, make multiple small passes to reduce the amount of material being removed at once. Also, check if the bit is dull and requires replacement. You can find replacements at Kregtool.com for PRS250/ PRS500.
What to do if the baseplate of Kreg PRS1000 Tools shifts during use?
If the baseplate of your Kreg Tools is shifting or moving during use, try these solutions: * Clean the GrippMaxx™ material on the underside of the base plate. * Ensure that the edge stop posts are all aligned to the material edge. * For hand router use, clamp the baseplate to the material.
Why doesn't the baseplate align to the material edge with Kreg PRS1000?
If the baseplate of your Kreg Tools does not align to the material edge, ensure that the material you are working with meets the minimum size requirements: at least 1/2" in thickness, 3.5" in width, and 7" in length.
Details and identification of all parts included in the set.
Instructions on how to store and use the profile templates.
How to position and adjust the edge stop posts for material width.
Steps for using the guide with trim or full-sized routers.
Instructions for using the guide with a router table.
To Next Page
General
