Kreg PRS1000 - Assembly; Profile Templates

4
Pre-Assembly (continued)
Recommended Tools (Not Included)
■ Kreg Flush-Trim Bit - 1/4" Shank (PRS250)
with dual bearings for trim routers that can
handle up to 1½" of material
■ Kreg Flush-Trim Bit - 1/2" Shank (PRS500)
with dual bearings for full-sized routers and
router tables that can handle up to 2" of
material
■ Kreg Precision Router Table System
(PRS1045)
■ Kreg Precision Benchtop Router Table
(PRS2100)
Assembly
1
Profile Templates
There are two parts bags that contain the prole templates.
a. To store the prole templates (E,F), snap the templates into the prole case (D).
b. To use a prole template (E,F), snap the desired prole into the posts (1) on the underside of
the Base Plate (A).
D
A
1
Optional: The prole case (D) may be installed for permanent placement
on the Kreg Multi-Purpose Shop Stand (KRS1035), [part of the Kreg
Precision Router Table System (PRS1045)]. The hole alignment on the shop
stand legs mirrors the keyholes on the prole case (D). (Recommended
hardware are two 10-24 machine screws with nuts. Not included.)