Kreg PRS1000 - Care and Cleaning; Troubleshooting; Accessories

7
Care and Cleaning
■ Wipe the prole templates (E, F) and base plate (A) clean of any dust and debris.
■ Clean the back base plate (A) with the GrippMaxx™ material with a damp cloth to keep it
clean and clear of saw dust and debris.
■ Keep the prole templates (E, F) in the prole case (D) to prevent loss.
■ Clean the router bit of dust and debris after use.
Troubleshooting
Problem Solution
Experiencing Chip Out
Make multiple small passes to minimize the material removed.
Bit may be dull and require replacement, see Kregtool.com for PRS250/
PRS500 replacements.
Experienced shifting or
movement of baseplate
Clean the GrippMaxx™ material on the underside of the base plate.
Make sure the edge stop posts all are aligning to the material edge.
Clamp the baseplate in place to the material for hand router use.
Baseplate does not align to
material edge
Ensure material thickness is at least 1/2" in thickness and 3.5" in width, and at
least 7" in length for minimal material use.
Accessories
Kreg Flush-Trim Bit - 1/4" Shank (PRS250) Kreg Flush-Trim Bit - 1/2" Shank (PRS500)