Krups Precision range XP80 - Page 9

1312
ENGLISH
PROBLEM CAUSE SOLUTION
The portalter cannot be
inserted to the brewing head.
The ground coee has not
been tamped correctly or the
quantity is excessive.
Refer to the Tamping section
in the user manual.
Put less ground coee in the
lter.
The machine fails to produce
espresso or very little
epsresso comes out.
No water in the tank,(The lack
of water light is ashing).
Fill the tank (2).
Water in the tank was running
out during the brewing.
Fill the tank. The launched
recipe will resume (2).
The water tank is not properly
in place and the valves at the
bottom are not open.
Press down lightly on the
tank to open the valves at the
bottom.
Coee ground too nely. Adjust the grinding level to
coaser (13).
Too much ground coee. Reduce the ground coee
quantity (15).
Coe ground tamped too
strongly
Reduce the tamping force.
Limescale in the water circuit. Descale the machine as
described in the user manual.
The espresso coee drips
from the edges of the
portalter instead of from the
holes.
The portalter is not correctly
in place.
Insert the portalter
correctly(25).
The coee spout gasket has
lost exibility or is dirty.
Contact a customer services
center to have it replaced.
Blockage in the coee lter. - Rinse the lter under
running water.
- Adjust the grinding settings
to coarser (13).
The espresso crema is too
thin, pale and delivered from
the spout too fast.
The machine settings are not
appropriate.
See instructions in section
“Adjust your espresso results”
in the user manual.
The espresso crema is too
dark and spotty (delivered
from the spout too low).
The machine settings are not
appropriate.
See instructions in section
“Adjust your espresso results”
in the user manual.
My coee is not hot enough. Machine is not heated
enough.
See instructions in section
“Adjust your espresso results”
in the user manual.
Coee preparation
temperature setting is low.
See instructions in section
“Adjust your espresso results”
in the user manual.
PROBLEM CAUSE SOLUTION
There is water in the drip tray. This water comes from
the internal circuits of the
machine and is a normal
consequence of their
operation.
Empty and clean the drip tray
on a regular basis (48).
After making 1st coee, I
can’t launch 2nd coee coee
just after.
Machine needs around
30seconds between the
cups in order to ensure good
temperature of coee.
You can use the grinder
during this waiting time.
Manometer doesn’t move. Coee brewing pressure is
too low.
To increase the pressure,
(1) Grinder ner (13)
(2) Increase the ground coee
quantity
(3) Tamp stronger.
I don’t nd Tamping station. Tamping station (& KRUPS
branded towel) comes only
with Precision+ (XP804T).
I can’t choose ‘1 CUP or
2CUP’, ‘Preinfusion time’ nor
‘Temperature’.
Either Hot water function,
Steam function or CALC is
chosen.
Select coee recipes
(Espresso, Lungo, Americano).
Not possible to change
the temperature for these
functions (52).
If it is not possible to determine the cause of the fault, consult an approved service centre. Never
disassemble the appliance! (if the appliance is disassembled, this will void the guarantee).
ELECTRICAL OR ELECTRONIC PRODUCT END OF LIFE
We participate in the protection of the environment!
Your product contains a number of materials that can be reused recycled.
Take it to a collection point or an approved service centre so that it can be
dealt with appropriately.