Krups Precision range XP80 - Making Hot Water

76
ENGLISH
1. Select HOT WATER on the recipes and cleaning dial (7).
2. Place a cup on the drip tray under the hot water outlet.
3. Once light indicator of the START/STOP BREW button (8) becomes xed white, press START/
STOP BREW button to start brewing. Delivery of the coee will stop automatically. You can
also press START/STOP BREW button to stop halfway.
If you have the Precision + version, you should nd the tamping and knocking box station.
1. This station will help you to get a stable tamping (59).
2. This station will help you to easily eject your coee cake (31).
Note: The bottom part of the station can be ipped over to rest securely on the edge of a table.
MAKING HOT WATER
a) Frothing milk
1. Fill your milk pitcher with the milk quantity that you want to froth (32), bearing in mind that the
milk doubles or triples in volume. 120ml/4.2 oz could be a good start. The best froth results will
be achieved using whole cow’s milk at refrigerator temperature (3-5°C/37,4 - 41 °F).
2. Select STEAM on the recipes cleaning dial (11): indicator light ashes, meaning the machine is
heating up. When the light becomes xed, immerse the steam wand in your milk pitcher (34).
3. Press START/STOP BREW button to start steaming (8).
4. After few seconds, move the pitcher down to have the end of the wand just on the surface of
the milk (35). Be careful not to remove the wand completely from the milk. There you will see
the froth creation. When you have enough milk froth, immerse the steam wand again for a
few seconds in the milk to heat it up (36).
5. Press again on the button START/STOP BREW button to stop the frothing (8).
6. Remove the milk pitcher from the machine.
TIPS:
• Before frothing, you can make a quick ush, meaning that you activate a few seconds the
steam in order to remove the condensed water from previous usage. Orientate the steam
nozzle towards the drip tray before doing so.
• Be sure to use fresh cold milk every time.
• Whole milk is recommended for best results.
• The result of you froth depends on the nature of the dairy or vegetable beverages used.
• After foaming milk, eliminate unwanted bubbles by swirling the pitcher gently and tapping
the bottom of the pitcher on a at surface.
b) Cleaning the steam wand
Do not forget to clean the wand after each frothing.
1. Take a wet towel and wipe the outside of wand to remove residual deposits of milk (37).
Warning: do not touch directly the steam wand just after frothing, it can be hot.
2. Release steam for a few seconds to clean the inside of wand (make sure your wand is
orientated toward the drip tray) (38).
3. Wait until the steam wand has cooled down. To ensure the wand works eciently over time,
use the cleaning pin to free the hole of any obstruction.
Note: Coee brewing, hot water and steam function cannot work at the same time, only one
function can work at once.
If you select a coee recipe just after using the steam function, the machine starts cooling down
automatically to make sure your next coee recipe is not burned. You will hear the intermittent
pump sound, light is ashing and some water goes into the drip tray. Once indicator light becomes
xed white, you can press START/STOP BREW button to extract your coee. During this automatic
function of the machine, the grinding functions are still available.
MAKING MILK BEVERAGES
TAMPING & KNOCKING BOX STATION
CLEANING
a) The Appliance
Unplug before each clean let the appliance cool down rst.
 Machine: Clean the outside of the appliance with a damp sponge when you think it necessary.
Do not use solvents or abrasive detergents to clean the coee machine.
 Water tank: Rinse the inside of the tank regularly. When a ne white layer appears in the tank,
descale the appliance (refer to the section on descaling).
 Drip tray: Clean the drip tray and its grid using water and a little mild detergent. Rinse and dry.
Portalter, lters: Using a damp cloth, clean the lter holder mount regularly in order to
remove possible coee residues stuck to the surface. In order to prolong the useful life of the
watertight seal on the brewing head, do not put the lter holder back in place if the coee
machine is not to be used for extended periods. To remove any deposits that could block the
ow of your 1 or 2 cup lter, you may use the needle. Filters are dishwasher safe.
 Steam wand: To prevent milk from drying inside the nozzle, please clean it after each use. To
do this, follow the steps for foaming the milk, replacing milk with water. Use a towel to clean the
outside of the grinder.
Summary of parts x cleaning method:
X X OK X X
OK OK OK X X
X OK OK X X
X OK OK X X
X X OK X OK
X OK OK X X
OK OK OK OK X
X X OK OK X
OK OK X X X