3 Transport/Storage/Disposal
9 of 34
KSB Leakage Sensor
1984.8/02-EN
3 Transport/Storage/Disposal
3.1 Checking the condition upon delivery
1. On transfer of goods, check each packaging unit for damage.
2. In the event of in-transit damage, assess the exact damage, document it and
notify KSB or the supplying dealer and the insurer about the damage in writing
immediately.
3.2 Transport
DANGER
Improper transport of the pump with fitted KSB Leakage Sensor
Risk of injury from falling parts!
▷ Never use the piping, leakage sensor or its fastening elements as attachment
points.
CAUTION
Improper transport
Damage to the device!
▷ Always transport the device properly and in its original packaging.
▷ For transport, observe the transport instructions on the original packaging.
▷ Do not throw the device.
1. Upon receipt, unpack the device and check for in-transit damage.
2. Report any in-transit damage to the manufacturer immediately.
3. Dispose of packaging material in accordance with local regulations.
3.3 Storage
If the ambient conditions for storage are met, the function of the device will be
ensured even after a prolonged period of storage.
CAUTION
Damage during storage due to humidity, dirt or vermin
Corrosion/contamination of the device!
▷ For outdoor storage cover the (packed or unpacked) device and accessories with
water-proof material.
Table4: Ambient conditions for storage
Ambient condition Value
Relative humidity 85% max. (non-condensing)
Ambient temperature -30°C to +60°C
1. Store the device in dry conditions and in its original packaging.
2. Store the device in a dry room in which the atmospheric humidity is maintained
at a constant level (as far as this is possible).
3. Prevent excessive fluctuations in atmospheric humidity.
To Next Page
Loading...