KTM 125 Duke Setup Instructions

WORK 3
9
3.9 Disconnecting the negative cable of the 12-V battery
Preparatory work
– Remove the passenger seat. ( p. 7)
– Remove the front rider's seat. ( p. 8)
V01273-10
Main work
–
Disconnect negative cable
1
of the 12-V battery.
3.10 Connecting the negative cable of the 12-V battery
V01273-10
Main work
–
Connect negative cable
1
of the 12-V battery.
Finishing work
– Mount the front rider's seat. ( p. 8)
– Mount the passenger seat. ( p. 8)
– Set time and date. ( p. 11)
3.11 Charging the 12-V battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep 12 V batteries out of the reach of children.
– Wear suitable protective clothing and safety glasses.
– Avoid contact with battery acid and battery gases.
– Keep sparks or open flames away from the 12 V battery.
– Only charge 12 V batteries in well-ventilated rooms.
– Rinse the affected area immediately with plenty of water in the event of contact with the skin.
– Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and
battery gases get into the eyes.
Note
Environmental hazard 12 V batteries contain environmentally hazardous materials.
– Do not dispose of 12 V batteries as household waste.
– Dispose of 12 V batteries at a collection point for used batteries.

KTM 125 Duke Specifications

General

Displacement	124.7 cc
Max Power	14.5 hp @ 9, 250 rpm
Max Torque	12 Nm @ 8, 000 rpm
Transmission	6-speed
Front Suspension	WP APEX 43
Rear Suspension	WP APEX Monoshock
Fuel Tank Capacity	13.4 liters
Seat Height	830 mm
Bore x Stroke	58 mm x 47.2 mm
Compression Ratio	12.8:1
Ground Clearance	175 mm
Wheelbase	1, 357 mm
Front Tyre	110/70 R17
Rear Tyre	150/60 R17
Fuel System	Electronic Fuel Injection (EFI)
Rear Brake	230 mm disc
Frame	Steel trellis frame, powder-coated
Engine Type	Single Cylinder, 4 Stroke, Liquid Cooled, DOHC