KTM 1290 SUPER DUKE R 2023 User Manual

SETUP 2
3
2.1 Transport mode
H02713-01
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
handing it over to the customer.
2.2 Diagnostics connector
S05685-10
Diagnostics connector
1
is located under the front rider's seat.
2.3 Unpacking and setting up the vehicle
Preliminary work
– Remove the box.
S04112-01
Main work
– Remove the adhesive tape in the upper area of the motorcycle.
S04113-01
– Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking,
leave the other films on the vehicle until you have fin-
ished work on the vehicle.
– Remove the separate enclosure and unpack it. Check that the
scope of supply is complete using the enclosed packing list.
Info
The procedure for missing components is described in
the Customer Service Manual.
– Check the vehicle for transport damage.

KTM 1290 SUPER DUKE R 2023 Specifications

General

Engine Type	2-cylinder, 4-stroke, V 75°
Displacement	1301 cc
Transmission	6-speed
Cooling	Liquid-cooled
Fuel Tank Capacity	16 liters
Seat Height	835 mm
Dry Weight	189 kg
Bore x Stroke	108 mm x 71 mm
Compression Ratio	13.5:1
Fuel System	Electronic fuel injection
Final Drive	Chain
Rear Suspension	WP APEX monoshock
Traction Control	MTC (Motorcycle Traction Control)
Wheelbase	1482 mm
Power	132 kW (180 hp)
Torque	140 Nm
Frame	Chromium-Molybdenum steel trellis frame, powder coated
Front Suspension	WP APEX 48
Front Brake	2 x Brembo Stylema Monobloc four-piston calipers, 320 mm discs
Rear Brake	Brembo two-piston caliper, 240 mm disc
ABS	Bosch 9.1 MP (incl. Cornering-ABS and Supermoto mode)
Electronics	Cruise Control