16 ELECTRICAL SYSTEM 143
500331-10
– Fold the headlight mask up.
–
Mount and tighten screws
1
.
Guideline
Remaining screws, chassis M5 5 Nm (3.7 lbf ft)
16.8 Checking the headlight setting
400726-10
– Park the vehicle on a horizontal surface in front of a light-colored wall and make a mark
at the height of the center of the low beam headlight.
–
Make another mark at a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle perpendicular to the wall at a distance
A
from the wall and switch
on the low beam.
Guideline
Distance
A
5 m (16 ft)
– The rider, with luggage and passenger if applicable, now mounts the motorcycle.
– Check the headlight setting.
The light-dark boundary must lie exactly on the lower mark when the motorcycle is
ready to operate with the rider mounted along with any luggage and a passenger if
applicable.
To Next Page
Loading...
