12 SERVICE WORK ON THE CHASSIS 58
102269-10
– Position the fork legs.
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
Position bleeder screws
toward the front.
102270-10
–
Tighten screws
.
Guideline
Screw, bottom triple clamp M8 15 Nm
(11.1 lbf ft)
102271-10
–
Tighten screw
.
Guideline
Screw, top steering head M20x1.5 12 Nm (8.9 lbf ft)
102272-10
–
Tighten screw
.
Guideline
Screw, top steering stem M8 20 Nm
(14.8 lbf ft)
102272-11
–
Tighten screws
.
Guideline
Screw, top triple clamp M8 20 Nm
(14.8 lbf ft)
102261-12
–
Position the brake caliper. Mount and tighten screws
.
Guideline
Screw, front brake caliper M8 25 Nm
(18.4 lbf ft)
Loctite
®
243™
–
Mount cable binder
.
– Position the brake line and wiring harness. Put on the clamp and mount and
tighten screws
.
To Next Page
Loading...
