KTM 2011 690 SMC EU User Manual (English)

Other manuals for KTM 2011 690 SMC EU

Questions and Answers:

D
Danielle BakerAug 17, 2025
What to do if my KTM 2011 690 SMC EU Motorcycle engine doesn't turn over when pressing the starter?
- R
  Robin TurnerAug 17, 2025
  If your KTM Motorcycle engine doesn't turn over when you press the starter, there could be several reasons: * You may not be following the correct start procedure. * The battery might be discharged, so recharge it. * A fuse (1, 2, 3, or 4) could be blown, so replace the blown fuse. * The main fuse might be burned out, so replace the main fuse. * There may be no ground connection, so check the ground connection.
J
James DaughertyAug 20, 2025
What to do if my KTM 2011 690 SMC EU Motorcycle engine turns over but won't start?
- M
  mcdanielchristopherAug 20, 2025
  If your KTM Motorcycle engine turns over but doesn't start, consider these possibilities: * You may not be following the correct start procedure. * Fuse 4 might be blown, so replace it. * The fuel hose connection might not be connected, so reconnect it. * The socket connector of the wiring harness might be oxidized; clean it and treat it with contact spray. * There may be a defect in the fuel injection system.
C
Cody CochranAug 22, 2025
Why does my KTM Motorcycle engine overheat?
- C
  Chris OdomAug 23, 2025
  Your KTM Motorcycle engine might be overheating due to several potential causes: * The radiator fins could be very dirty, so clean them. * There might be foam formation in the cooling system, so drain the coolant. * A radiator hose could be buckled or damaged, so replace the radiator hose. * The thermostat may be faulty, so check it. * Fuse 5 might be blown, so replace the fuse. * There could be a defect in the radiator fan system, so check the radiator fan system. * There might be air in the cooling system, so fill the cooling system.
E
Elizabeth FoxAug 25, 2025
Why does my KTM Motorcycle engine die while I'm riding?
- S
  stephen38Aug 26, 2025
  If your KTM Motorcycle engine dies during a ride, it could be due to: * Lack of fuel, so refuel. * A blown fuse (1, 2, or 4), so replace the affected fuse.
R
Ryan FrazierAug 28, 2025
How to reduce high oil consumption in my KTM 2011 690 SMC EU Motorcycle?
- J
  Jennifer SpenceAug 28, 2025
  To address high oil consumption in your KTM Motorcycle: * Ensure the engine vent hose isn't bent; route it without bends or replace it if needed. * Check the engine oil level, it might be too high. * The engine oil might be too thin, so change the engine oil and filter, and clean the oil screens.
J
James BurtonAug 30, 2025
What does it mean if the FI warning lamp (MIL) lights or flashes on my KTM 2011 690 SMC EU Motorcycle?
- B
  Brittany LewisAug 30, 2025
  If the FI warning lamp (MIL) is lighting up or flashing on your KTM Motorcycle, it indicates a potential defect in the fuel injection system.
J
Jordan SilvaSep 2, 2025
Why aren't the headlight and parking light working on my KTM Motorcycle?
- C
  Charles MeadowsSep 2, 2025
  If the headlight and parking light are not functioning on your KTM Motorcycle, it is possible that fuse 7 is blown. Replace the fuse.
S
Sheri RobertsSep 5, 2025
Why aren't the turn signal, brake light, and horn working on my KTM Motorcycle?
- R
  Randall HowellSep 5, 2025
  If the turn signal, brake light, and horn aren't working on your KTM Motorcycle, the cause may be that fuse 6 is blown. Replace the fuse.
B
bjenkinsSep 8, 2025
What should I do if the speedometer isn't working on my KTM 2011 690 SMC EU Motorcycle?
- B
  Bridget KnightSep 8, 2025
  If the speedometer in the combination instrument is not functioning on your KTM Motorcycle, check the wiring harness and plug-in connection for damage or oxidation.

KTM 2011 690 SMC EU Specifications

General

Engine Type	Single cylinder, 4-stroke
Displacement	654 cc
Bore x Stroke	102 mm x 80 mm
Compression Ratio	11.8:1
Starter	Electric starter
Transmission	6-speed
Cooling	Liquid cooled
Rear Suspension	WP Monoshock
Suspension Travel Front	275 mm
Suspension Travel Rear	250 mm
Front Tire	120/70 ZR17
Rear Tire	160/60 ZR17
Steering Head Angle	63.5°
Seat Height	890 mm
Power	67 hp
Torque	65 Nm
Fuel System	Electronic Fuel Injection
Clutch	Wet multi-disc clutch, hydraulically operated
Frame	Steel trellis frame
Front Suspension	WP USD Ø 48 mm
Front Brake	Brembo four-piston radial caliper, 320 mm disc
Rear Brake	Single 240 mm disc
ABS	Yes, switchable
Front Rim	3.50 x 17
Rear Rim	5.00 x 17"
Tank Capacity	12 liters
Wheelbase	1480 ± 15 mm

Summary

Means of Representation

Important Information and Warnings

General Vehicle Information

Defines intended use, service requirements, warranty, and fuel specifications.

Operational Guidelines and Safety

Covers spare parts, work rules, transport, environmental responsibility, and warnings.

Risk Classification and Manual Usage

Explains risk grades (Danger, Warning, Caution, Note) and importance of the owner's manual.

View of Vehicle Components

Front Left Vehicle View

Labeled diagram illustrating components from the front left perspective.

Rear Right Vehicle View

Labeled diagram illustrating components from the rear right perspective.

Serial Numbers and Identification

Chassis, Engine, and Key Numbers

Location and importance of chassis, engine, and key identification numbers.

Component Part Number Identification

Identifies part numbers for specific components like fork and shock absorber.

Motorcycle Controls

Handlebar and Ignition Controls

Operation of levers, switches, buttons, and the ignition/steering lock.

Combination Instrument Functions

Details on display, indicators, trip meters, speedometer, and clock.

Other Controls and Access

Operation of filler cap, seat release, handrails, footrests, and stands.

Preparing for Use

First Use and Engine Running-In

Guidance for initial operation, engine break-in, and rider preparation.

Vehicle Loading and Payload

Instructions for safe weight distribution and maximum load limits.

Riding Instructions

Pre-Ride Checks and Vehicle Care

Essential checks and maintenance before riding.

Starting and Riding Procedures

Steps for starting, moving off, shifting gears, and general riding advice.

Braking and Stopping Techniques

Proper braking methods, conditions, and stopping distances.

Parking and Refueling Procedures

Procedures for parking, securing, and refueling the motorcycle.

Service Plan

Scheduled Maintenance Intervals

Maintenance tasks and intervals for different service periods.

Tuning the Chassis

Suspension Adjustment Guide

Tuning fork and shock absorber compression and rebound damping.

Service Work on the Chassis

Chain and Sprocket Maintenance

Cleaning, tensioning, and inspection of drive chain and sprockets.

Clutch Adjustment and Fluid Check

Adjusting clutch lever and checking hydraulic fluid.

Brakes

Brake Lever and Disc Checks

Adjusting hand brake lever and checking brake disc wear.

Brake Fluid and Linings Maintenance

Checking/adding brake fluid and inspecting brake linings.

Wheels and Tires

Wheel Removal and Installation

Step-by-step guide for fitting and removing front/rear wheels.

Tire and Spoke Care

Checking tire condition, pressure, age, and spoke tension.

Electrical System

Battery Maintenance and Charging

Battery removal, installation, and charging procedures.

Fuse Replacement Guide

Guidance on replacing main and individual fuses.

Headlight System Adjustments

Headlight mask, bulb replacement, and beam adjustment.

Cooling System

Coolant Level and Antifreeze Checks

Procedures for checking coolant level and antifreeze protection.

Coolant System Draining and Filling

Procedures to drain and refill the cooling system.

Tuning the Engine

Throttle Cable and Engine Map Tuning

Adjusting throttle cable play and selecting engine performance maps.

Service Work on the Engine

Engine Oil Level and Filter Service

Checking oil level, changing oil/filter, and cleaning oil screens.

Adding Engine Oil Procedures

Correct method for adding engine oil to maintain proper level.

Cleaning and Care

General Motorcycle Cleaning

Recommended methods for washing, drying, and protecting the motorcycle.

Winter Operation and Protection

Advice for winter use and corrosion prevention.

Storage Procedures

Motorcycle Storage Guidelines

Steps for preparing and storing the motorcycle for extended periods.

Preparing for Use After Storage

Steps to take the motorcycle out of storage and prepare it for riding.

Troubleshooting Guide

Blink Code Diagnostics

Technical Data - Engine

Engine Specifications and Capacities

Key technical data for the engine and fluid capacities.

Technical Data - Chassis

Chassis Specifications and Tire Data

Technical details on chassis, suspension, tires, and fuel capacity.

Technical Data - Fork

Technical Data - Shock Absorber

Technical Data - Chassis Tightening Torques

Substances and Fluids

Recommended Fluids and Lubricants

Lists of recommended brake fluids, coolants, oils, and fuel types.

Auxiliary Substances

Cleaning, Care, and Lubrication Products

Recommended auxiliary products for motorcycle maintenance and cleaning.

Standards Information

Related product manuals

KTM 2013 690 SMC R EU

230 pages

KTM 2014 690 SMC R EU

248 pages

KTM 2008 690 SMC EU

227 pages

KTM 690 SMC R EU 2021

KTM 690 SMC R 2016 Series

KTM 2011 690 SMC EU User Manual

Table of Contents