SERVICE WORK ON THE CHASSIS 75
601273-10
– Check that the chain guide is firmly seated.
» If the chain guide is loose:
– Tighten the chain guide.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
– Remove the motorcycle from the lift stand.
10.15Adjusting basic position of clutch lever
Info
Turn the adjusting screw clockwise to increase the distance between the clutch lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!
100282-10
– Adjust the basic setting of the clutch lever to your hand size by turning adjusting
screw .
– When adjusting the clutch lever make sure that there is a minimum clearance to other
parts of the vehicle.
Guideline
Minimum clearance 5 mm (0.2 in)
To Next Page
Loading...
