14 WHEELS, TIRES 115
M00463-10
–
Clean the thread of the wheel spindle and screw
.
– Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
.
Guideline
Screw, front wheel spindle M8 20 Nm
(14.8 lbf ft)
–
Position wheel speed sensor
in the drill hole. Mount and tighten screw
.
Guideline
Screw, wheel speed sensor
holder
M6 9 Nm
(6.6 lbf ft)
Loctite
®
243™
–
Mount and tighten screws
.
– Operate the hand brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
– Take the motorcycle off of the front wheel stand. ( p. 80)
– Pull the front brake and compress the fork forcefully a few times.
The fork legs straighten.
–
Tighten screws
.
Guideline
Screw, fork stub M8 15 Nm
(11.1 lbf ft)
Finishing work
– Take the motorcycle off of the front wheel stand. ( p. 80)
– Take the motorcycle off of the rear wheel stand. ( p. 78)
To Next Page
Loading...
Need help?
General
