15 ELECTRICAL SYSTEM 132
15.6 Changing the low beam bulb
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
Preparatory work
– Switch off all power consumers and switch off the engine.
L02161-10
Main work
–
Turn socket
counterclockwise.
–
Pull the socket with low beam bulb
out of the headlight housing.
–
Disconnect the socket with the low beam bulb from connector
and remove.
– Connect the new socket with the low beam bulb to the connector.
Low beam (H11 / Sockel PGJ19-2) ( p. 177)
To Next Page
Loading...
