11 SERVICE WORK ON THE CHASSIS 32
400738-11
Main work
– Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
» If there is noticeable play present:
–
Adjust the play of the steering head bearing. x ( p. 32)
– Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. No
resting locations should be noticeable.
» If click positions are noticeable:
–
Adjust the play of the steering head bearing. x ( p. 32)
– Check the steering head bearing and replace if required.
Finishing work
– Remove the motorcycle from the lift stand. ( p. 27)
11.11 Adjusting the play of the steering head bearing x
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 27)
101937-10
Main work
– Remove fuel tank breather 1.
– Loosen screws 2.
– Loosen screw 3.
– Loosen and retighten nut 4.
Guideline
Nut, steering head M20x1.5 No play
≤ 9 Nm
(≤ 6.6 lbf ft)
Only applies when
using:
Key for steer-
ing head bearing
(45229050000)
– Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
– Tighten screw 3.
Guideline
Screw, top triple clamp M8 20 Nm
(14.8 lbf ft)
– Tighten screws 2.
Guideline
Screw, top triple clamp M8 20 Nm
(14.8 lbf ft)
– Position the fuel tank breather 1.
Finishing work
– Check play of steering head bearing. ( p. 31)
– Remove the motorcycle from the lift stand. ( p. 27)
11.12 Greasing the steering head bearing x
400563-01
–
Remove the lower triple clamp. x ( p. 29)
–
Install the lower triple clamp. x ( p. 30)
To Next Page
