15 TUNING THE ENGINE 66
S00001-10
– Remove screws 1.
– Remove clutch cover 2 with the seal ring.
15.10 Adjusting the clutch x
Preparatory work
–
Remove the clutch cover. x ( p. 65)
S00002-10
Main work
– Turn the outer clutch hub 1 until adjusting screws 2 become accessible.
S00003-10
Condition
If there is no reference point:
– Turn adjusting screws 2 counterclockwise to the last detectable click.
– Turn adjusting screws 2 clockwise by 9 clicks to the basic setting.
Guideline
Basic setting of slip speed 8,700… 9,300 rpm
Info
The springs may not be pretensioned by more than 17 clicks from the
stop using the adjusting screws.
Condition
If the slip speed is too low:
– Turn adjusting screws 2 clockwise.
Guideline
1 click increases the slip speed by 250… 350 rpm
Info
The springs may not be pretensioned by more than 17 clicks from the
stop using the adjusting screws.
Condition
If the slip speed is too high:
– Turn adjusting screws 2 counterclockwise.
Guideline
1 click decreases the slip speed by 250… 350 rpm
Finishing work
–
Install the clutch cover. x ( p. 67)
– Check the gear oil level. ( p. 69)
–
Check the clutch setting. x ( p. 65)
To Next Page
