3 WORK 6
3.1 Removing the seat
101977-10
–
Pull on strap
and raise the rear of the seat at the same time.
– Pull back the seat and lift it off.
3.2 Mounting the seat
101988-10
–
Hook slot
of the seat onto screw
, press the rear downward and at the same time push it forward.
–
Push locking pin
into lock housing
and push the back of the seat down until the locking pin locks in place with an audible
click.
– Check, finally, that the seat is correctly mounted.
3.3 Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep batteries out of the reach of children.
– Wear suitable protective clothing and goggles.
– Avoid contact with battery acid and battery gases.
– Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
– In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Preparatory work
– Switch off all power consumers and switch off the engine.
– Remove the seat. ( p. 6)
B01974-10
Main work
–
Remove battery cover
.
–
Pull the EFI control unit
off of the holder and set it to one side.
To Next Page
Loading...
