16 KTM POWERPACK, BATTERY CHARGER 99
– Disconnect the residual current protection switch from the mains connection.
16.6 Recharging the KTM PowerPack
Note
Material damage The power supply will be damaged in the event of an overload.
In charge mode Fast, a steady current of at least 13 A is required.
In charge mode Normal, a steady current of at least 10 A is required.
– Ensure that the power outlet can supply the steady current required and is protected by a suitable fuse.
Warning
Environmental hazard Lithium-ion batteries contain components and elements that are harmful to the environment.
– Never throw a KTM PowerPack into the household trash.
– Dispose of the KTM PowerPack properly and in compliance with the applicable regulations.(Your authorized KTM workshop
will be glad to help.)
Info
The procedure used for recharging is identical both when the battery is installed and when it is not installed. However, the
12 V battery is only recharged when the KTM PowerPack is being recharged in the vehicle.
Recharge the KTM PowerPack regularly while it is inside the vehicle to also charge the 12 V battery.
When the battery charger is connected to the KTM PowerPack, do not activate the vehicle.
If the vehicle is activated while recharging with the KTM PowerPack installed in the vehicle, the vehicle will switch to error
mode. The KTM PowerPack will continue to be recharged, however the 12 V battery will stop recharging.
Info
When the left LED in the charge level indicator on the battery charger flashes, then the KTM PowerPack is ready for use. How-
ever, its full capacity will not yet be available.
To guarantee the maximum capacity of the KTM PowerPack, discharge the KTM PowerPack completely every 20 charging
cycles and then recharge it completely. If this process is not carried out, then the vehicle may switch off due to a charging
level which is too low without reducing power beforehand.
The KTM PowerPack is completely discharged when the vehicle switches off with blink code 11.
Info
When the temperature of the KTM PowerPack exceeds the permitted value during charging, the battery charger will stop the
charging process. All LEDs and the LEDs for the current charge level light up alternately every second.
As soon the temperature of the KTM PowerPack returns to the permitted range, the charging process continues automatically.
Preparatory work
– Position the battery charger. ( p. 98)
– Check residual current protection switch. ( p. 98)
– Push the main switch into the position .
– Fold the seat up. ( p. 63)
C00815-10
Main work
–
Remove the charging socket protection cap
.
Warning
Risk of injury The intrinsic safety of the KTM PowerPack can only be guar-
anteed if the original battery charger is used.
The KTM PowerPack may only be charged with the original battery charger.
– Only use the original battery charger to charge the KTM PowerPack.
–
Connect the battery charger to the KTM PowerPack. Observe the plug markings
.
To Next Page
Loading...
