KTM Freeride E-XC - Installing the Lower Triple Clamp

12 SERVICE WORK ON THE CHASSIS 55
C00835-10
(Freeride E‑XC)
–
Open holder

and detach the wiring harness and brake line.
C00836-10
–
Remove screw

.
–
Remove screw

.
– Take off the upper triple clamp with the handlebar and set it aside.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
C00693-10
–
Remove O-ring

and protective ring

.
– Take off the lower triple clamp with the steering stem.
– Remove the upper steering head bearing.
12.10 Installing the lower triple clamp
0
0
C00759-10
Main work
(Freeride E‑SX)
– Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease ( p. 122)
– Insert the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
–
Check whether the upper steering head seal

is correctly positioned.
–
Push the protective ring

and O-ring

onto the steering stem.
C00695-10
– Position the upper triple clamp with the handlebar.
–
Mount screw

but do not tighten yet.
– Position the rear wheel brake line and wiring harness.