KTM RC 125 Setup Instructions

WORK 3
13
– Set the clock. ( p. 13)
3.14 Installing the 12-V battery
V00664-11
Main work
–
Mount rubber strap
1
on the battery compartment.
– Position the 12-V battery in the battery compartment.
Guideline
The terminals of the battery must face upwards.
12-V battery (ETZ-9-BS)
–
Attach rubber strap
1
.
–
Position positive cable
2
and mount and tighten the screw.
–
Position positive terminal cover
3
.
V00663-11
–
Position negative cable
4
; mount and tighten the screw.
Finishing work
– Mount the battery cover. ( p. 10)
– Mount the front rider's seat. ( p. 10)
–
Set the clock. ( p. 13)
3.15 Setting the clock
Info
The time is displayed in 24-hour format.
The time must be reset if the 12-V battery was disconnected from the vehicle or the fuse was removed.
Condition
The motorcycle is stationary.
F01455-10
–
Press the MODE button briefly and repeatedly until ODO appears
on the display.
– Press the MODE button and SET button simultaneously for 5
seconds.
The time display begins to flash.
Info
The clock can be set in the ODO display for each menu
by keeping the MODE button and SET button pressed
simultaneously.
– Set the hours display using the MODE button.
– Set the minutes display using the SET button.

KTM RC 125 Specifications

General

Displacement	124.7 cc
Transmission	6-speed
Fuel System	Electronic Fuel Injection
Bore x Stroke	58 mm x 47.2 mm
Engine Type	Liquid-cooled, 1-cylinder, 4-stroke engine
Max Torque	12 Nm @ 8, 000 rpm
Front Suspension	WP upside-down fork
Rear Suspension	WP Monoshock
Front Brake	Single disc, 4-piston caliper
Rear Brake	Single disc, single-piston caliper
Frame	Steel trellis frame
Front Tire	110/70 R17
Rear Tire	150/60-17