SETUP 2
3
2.1 Transport mode
H02713-01
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
handing it over to the customer.
2.2 Diagnostics connector
H01911-10
Diagnostics connector
1
is located under the front rider's seat.
2.3 Unpacking and setting up the vehicle
A00034-10
– Remove the straps and the box.
S01886-01
– Remove the adhesive tape in the upper area of the motorcycle.
To Next Page
Loading...
