CLEANING, CARE 20
221
– After cleaning, ride the vehicle a short distance until the
engine warms up.
Info
The heat produced causes water at inaccessible loca-
tions in the engine and on the brake system to evapo-
rate.
– Push back the sleeves of the handlebar controls to allow any
water that has penetrated to evaporate.
– After the motorcycle has cooled down, lubricate all moving
parts and pivot points.
– Clean the chain. ( p. 120)
– Treat bare metal (except for brake discs and the exhaust sys-
tem) with a corrosion inhibitor.
Preserving materials for paints, metal and rubber
( p. 250)
– Treat all painted parts with a mild paint care product.
Perfect finish and high gloss polish for paints ( p. 249)
Info
Do not polish parts that were matte when delivered as
this would strongly impair the material quality.
To Next Page
Loading...
