10 OPERATING THE TRACTOR
OPERATING THE TRACTOR
STARTING
[With Dual Speed model]
BOperator's Seat
To avoid personal injury:
A Make adjustments to the seat only while the
tractor is stopped.
A Make sure that the seat is completely secured
after each adjustment.
A Do not allow any person other than the
operator to ride on the tractor.
(1) Travel adjust lever
(2) Weight / Height adjust lever
(3) Backrest tilt adjust lever
(4) Arm rest
(5) Arm rest angle adjust knob
(A) "UNLOCK"
(B) "TO INCREASE ANGLE"
(C) "TO DECREASE ANGLE"
C Travel adjustment
Unlock the travel adjust lever and slide the seat
backward or forward, as required. The seat will lock in
position when the lever is released.
C Weight and Height adjustment
Turn on the key switch. The seat should be adjusted for
the operator's weight by briefly pulling up or pushing
down the weight / height adjust lever with the tractor in a
stationary position and the operator sitting on the seat.
The seat can be adjusted in its adjustable range.
A If the seat is lowered below the adjustable range, it
automatically comes up to the lower limit of the
adjustable range just when the weight / height adjust
lever is released.
A When turning on the key switch, the seat may slightly
move up depending on a preset seat position
(height).
A In order to avoid damage of the seat, do not operate
the weight / height adjust lever for more than 1
minute.
C Tilt adjustment
Pull the backrest tilt adjust lever and tilt the backrest to
the desired position.
C Arm rest
Armrest may be set at upright position if desired.
C Arm rest angle adjustment
Turn the arm rest angle adjust knob to the desired angle.
A After adjusting the operator's seat, be sure to check
to see that the seat is properly locked,
To Next Page
