TIRES, WHEELS AND BALLAST24
BRear Wheels
Rear tread width can be adjusted as shown with the
standard equipped tires.
To change the tread width
1. Remove the wheel rim and / or disk mounting bolts.
2. Change the position of the rim and / or disk (right and
left) to the desired position, and tighten the bolts.
A Always attach wheels as shown in the drawing.
A If not attached as illustrated, transmission parts may
be damaged.
A When re-fitting or adjusting a wheel, tighten the bolts
to the following torques then recheck after driving the
tractor 200m (200 yards) and thereafter according to
service interval.
(See "MAINTENANCE" section.)
N-m (kgf-m)
(1) (2)
M6040, M7040 260 to 304 (26.5 to 31.0)
260 to 304
(26.5 to 31.0)
M8540, M9540 343 to 402 (35.0 to 41.0)
To Next Page
