23TIRES, WHEELS AND BALLAST
BFront Wheels (with four wheel drive)
Front tread width can be adjusted as shown with the
standard equipped tires.
To change the tread width
1. Remove the wheel rim and disk mounting bolts.
2. Change the position of the rim and disk (right and left)
to the desired position, and tighten the bolts.
3. Adjust the toe-in: [ 2 to 8mm ]
See "Adjusting Toe-in" in "EVERY 200 HOURS" in
"PERIODIC SERVICE" section.
A Always attach wheels as shown in the drawing.
A If not attached as illustrated, transmission parts may
be damaged.
A When re-fitting or adjusting a wheel, tighten the bolts
to the following torques then recheck after driving the
tractor 200m (200 yards) and thereafter according to
service interval. (See "MAINTENANCE" section.)
A Wheels with beveled or tapered holes: Use the
tapered side of lug nut.
(1) 260 to 304 N-m (26.5 to 31 kgf-m)
M6040
M7040
9.5-24 1420 mm 1440mm 1520 mm
9.5-22 1510 mm --- ---
M8540
M9540
12.4-24 1560 mm 1540mm 1660 mm
360/70R24 1560 mm 1540mm 1660 mm
To Next Page
Loading...
