17PTO
To Turn OFF
Tap on top of the switch, and the switch will return to the
OFF position.
A To avoid shock loads to the PTO, reduce engine
speed when engaging the PTO, then open the throttle
to the recommended speed.
A Tractor engine will not start if PTO clutch control switch
is in the engaged "ON" position.
A If the PTO system is engaged and you stand up from
the seat, the warning buzzer will whistle for about 10
seconds after standing up.
This is because the tractor is equipped with "Operator
Presence Control System".
C PTO Clutch Indicator
The PTO clutch indicator turns on while PTO clutch
control switch is in "ON" (Engage) position.
BLCD Monitor Message
1. The PTO rpm can be checked in the LCD monitor.
(See "PTO RPM / TRAVEL SPEED MONITOR" in
"OPERATING THE TRACTOR" section.)
2. When the PTO system gets engaged (ON), the
indicator lights up.
(A) "PUSH"
(1) PTO clutch indicator
(1) LCD monitor
(2) PTO clutch indicator
To Next Page
