Kubota V3300-E2B - Check Points of Every 1 Year

G-23
V3300-E2B, V3300-T-E2B, WSM
G GENERAL
[10] CHECK POINTS OF EVERY 1 YEAR
Changing Engine Oil
CAUTION
• Be sure to stop engine before changing engine oil.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw the drain plug (1).
5. Fill new oil up to upper line on the dipstick (2).
IMPORTANT
■
• When using an oil of different maker or viscosity from the
previous one, remove all of the old oil.
• Never mix two different types of oil.
• Engine oil should have properties of API classification CD/
CE/CF/CF-4/CG-4.
• Use the proper SAE Engine Oil according to ambient
temperature.
W1019006
Replacing Air Cleaner Element
1. Remove used air cleaner element.
2. Replace new air cleaner element.
NOTE■
• The air cleaner uses a dry element. Never apply oil to it.
• Do not run the engine with filter element removed.
W1020554
Above 25 °C (77 °F)
SAE 30 or SAE 10W-30
SAE 10W-40
0 °C to 25 °C (32 °F to 77 °F)
SAE 20 or SAE 10W-30
SAE 10W-40
Below 0 °C (32 °F)
SAE 10W or SAE 10W-30
SAE 10W-40
Engine oil capacity
13.2 L
3.49 U.S.gals
(1) Drain Plug (2) Dipstick
KiSC issued 06, 2006 A