ECM SYSTEM
WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, DM
1-88
WEATHER PACK CONNECTOR
A Weather-Pack connector can be identified by a
rubber seal installed to the wire at the rear of the
connector. This type of connector is use in the engine
compartment to protect against moisture intrusion into
the connector. Refer to Figure 4 for terminal removal and
repair.
1. Open the secondary lock hinge to the female
connector and separate the connectors.
2. Remove the terminal using the pin tool.
3. Cut the wire immediately behind the cable seal.
4. Replace the terminal
a) Slip the new seal onto the wire.
b) Strip 5 mm (0.2 in.) of insulation from the wire.
c) Crimp the terminal over the wire and seal.
5. Push the terminal back into the connector until the
locking tangs are seated.
6. Connect the male and female terminals.
7. Close the secondary locks.
(1) Male Connector
(2) Female Connector
(3) Secondary Lock Hinge
(4) Tool J-28742 / BT8234-A
(5) Terminal
(6) Seal
(7) Wire
(8) Terminal
(9) Wire harness terminal
To Next Page
Loading...
