29
CONTROL LOCATIONS & FUNCTIONS
SEAT LATCH
To remove the seat, lift up on the latch① release which located
at the rear of the seat, then raise the rear part of the seat and
slide it rearward.
To remount the seat, slide the front of the seat into the seat
retainers and push down firmly on the rear of seat.
The seat should automatically latch into position.
Make sure the seat is secure before mounting and riding
the ATV. Severe personal injury may result if the seat is not
properly secured.
FLAG POLE BRACKET
The rear rack of your ATV is equipped with a flag pole bracket.
Flag poles are optional equipment available from your KYMCO
dealer. Mounting a flag pole to your ATV, via the flag pole
bracket, increases your visibility during operation.
NOTE: Flag poles are required safety items in some
riding areas. Check the local regulations before riding.