Using the Operation Panel 2-79
3 Once you enter the correct ID and password, the Admin (change)
screen appears. (E.g.: Where the administrator ID is 00000001)
Each time you press U or V, the following settings to be changed
appear in succession.
• Change ID
• Change Password
4 Press [OK] again. The administrator ID and password are
confirmed.
5 Press [MENU]. The display returns to Ready.
Change ID (Administrator ID change)
You can use this to change the administrator ID.
1 In step 3 in Password (Administrator Password input) above, press
U or V while the Admin (Change) screen is displayed until
>Change ID appears. (E.g.: Where the administrator ID is 001)
2 When you press [OK], a blinking cursor (_) appears.
3 Press U or V to increase or decrease, respectively, the value at the
blinking cursor. Enter the ID to be changed. Use Y and Z to move
the cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
4 Press [OK]. A confirmation screen appears. (E.g.: Where the
administrator ID is changed to 002)
5 Press [OK]. The new administrator ID is confirmed.
6 Press [MENU]. The display returns to Ready.
Change Password (Administrator Password change)
You can use this to change the administrator password.
1 In step 3 in Password (Administrator Password input) above, press
U or V while the Admin (Change) screen is displayed until
>Change Password appears.
2 Press [OK]. A blinking cursor (_) appears.
3 Press U or V to increase or decrease, respectively, the value at the
blinking cursor. Enter the password to be changed. Use Y and Z to
move the cursor right and left. Enter a password consisting of
between 0 and 16 numbers.
4 Press [OK]. A confirmation screen appears. (E.g.: Where the
administrator password is changed to 010)
Note If a change is required, refer to the procedures in
Change ID (Administrator ID change) and Change
Password (Administrator Password change) below.
To Next Page
Loading...
Need help?
General
