4-47
Using the Operation Panel
2 Press U or V repeatedly until >TCP/IP > appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using U or V.
5 Select On and press [OK]. Configure the settings shown below.
DHCP (DHCP setting)
DHCP (Dynamic Host Configuration Protocol) is the protocol that assigns
the information required to establish a network connection when a host
attempts to connect to the network (Internet). This information includes
the IP address of the local node and the default router (the router in the
host's own network system) and the DNS (Domain Name System) server.
DHCP is an extension of the BOOTP (Bootstrap) startup protocol.
1 Press Z while >TCP/IP On > is displayed.
2 Press U or V repeatedly until >>DHCP appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using U or V.
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
Auto-IP (Auto-IP setting)
This protocol is used for automatic assignment of an IP address when you
connect to a small network that does not have a DHCP server. Select an
address from the range 169.254.0.1 to 169.254.255.254, and if no other
device on the network is using that address, it is used as your address.
1 Press Z while >TCP/IP On > or >TCP/IP Off > is displayed.
2 Press U or V repeatedly until >>Auto-IP appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using U or V.
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
IP Address (IP address setting)
An IP address is the address of a network device such as a computer and
is included in IP packets as needed for the sending and receiving of
Internet data (IP packets). (IP addresses can be either destination
addresses or source addresses.)
Specifically, an IP address is a bit string consisting of a host address (or
host section) that identifies a computer (host) connected to the Internet
and a network address (or network section) that identifies the network to
which that computer belongs (or more specifically, the computer's
>TCP/IP >
?Off
>>DHCP
?Off
>>Auto-IP
?Off
To Next Page
Loading...
Need help?
General