Using the Operation Panel
4-10
Setting a Mode Selection Menu
This section explains the setting procedures used for each menu item in
the mode selection menu.
1 While the printer displays Ready, Please wait, Sleeping and
Processing, press [MENU]. The mode selection menu is
displayed. (For example : Report Print)
2 Each time you press U or V, the selection changes.
• Report Print
• USB Memory
•Custom Box
• Job Box
• Counter
• Paper Settings
• Print Settings
•Network
• Device Common
• Security
• Job Accounting
•Admin
• Adjust/Maintenance
IMPORTANT The Custom Box option appears in the mode selection
menu when the hard disk is installed. The
Job Box option appears
when the hard disk is installed or the RAM disk has been set up.
For more information, please refer to Custom Box (Using a Custom
Box) on page 4-18, Job Box on page 4-22 or RAM Disk Mode (Using
the RAM disk) on page 4-55.
Report Print >
Note If you use the mode first selected when the printer is turned
on, Report Print is displayed. For the second and subsequent
times, the last menu option you selected the previous time is
displayed.
To Next Page
Loading...
Need help?
General