Kyocera FS-1016MFP

2G4
1-4-4
[SCANNER ERROR]
Motor Stall
Scanner motor stall for
scanner.
Defective scanner
belt spring.
Replace the scanner belt spring.
Poor contact in scan-
ner motor connector
terminals.
Reinsert the connector (See page P.1-5-
36).
Defective FFC
between main PWB
and CCD PWB, or
improper connector
insertion.
Reinsert the FFC. Also check for continuity
within the FFC. If none, remedy or replace
the FFC (See page P.1-5-29, P.1-5-28).
Defective scanner
motor.
Replace the scanner motor (See page P.1-
5-36).
Defective main PWB. Turn the power switch off and then back on
again. If this message still remains, replace
the main PWB (See page P.1-5-29).
Defective scanner
unit.
Replace the scanner unit (See page P.1-5-
22)
Toner Low Toner low for printer. Toner is running low. Replace the toner container.
Defective toner con-
tainer.
Replace the toner container.
Defective main PWB. Replace the main PWB (See page P.1-5-
29).
Please Replace
Toner
Toner empty for
printer.
Toner has run out so
further copying or
printing is impossible.
Replace the toner container.
Defective toner con-
tainer.
Replace the toner container.
Defective main PWB. Replace the main PWB (See page P.1-5-
29).
Service error message Contents
Remarks
Causes Check procedures/corrective measures