Kyocera FS-1016MFP

2G4
1-5-37
1-5-7 Document processor (DP)
(1) Detaching and refitting the document processor (DP)
<Procedure>
1. Remove the scanner unit (See page P.1-5-
22).
2. Remove the original table (See page P.1-5-
24).
3. Remove the six screws and then remove the
main PWB cover.
4. Remove the connector from main PWB.
Figure 1-5-50
5. Remove the two screws and then remove
the DP signal cable.
6. While unlocking the both hinge locks and
then remove the document processor (DP).
7. Check or replace the document processor
(DP) and refit all the removed parts.
Figure 1-5-51
Screw
Screw
Screw
Screw
Screw
Screw
Main PWB cover
Main PWB
Scanner unit
Connector
Document processor (DP)
Screws
DP signal
cable
Hinge lock
Hinge