2G4
1-5-20
(6) Detaching and refitting the drive unit
<Procedure>
1. Remove the right cover (See page P.1-5-2).
2. Remove the three connectors.
3. Remove the two screws and then remove
the two grounding plates.
4. Remove the two stoppers and then remove
the two clutches.
Figure 1-5-25
5. Remove the three screws and then remove
the drive unit.
6. Check or replace the drive unit and refit all
the removed parts.
Figure 1-5-26
Screw
Screw
Clutch
Connectors
Clutch (black)
Grounding plate
Grounding plate
Stopper
Stopper
Screw
Screw
Screw
Drive unit
To Next Page
Loading...
