Kyocera FS-1016MFP - Combine Mode for Multiple Originals

2G4
1-4-10
6010 Fuser low temperature
After the fuser heater lamp is turned on,
the temperature at the upper fuser roller
lower than 100
°C/212 °F continues for
30 s.
Defective the fuser
thermistor.
Follow the flow chart.
Defective the
engine/high volt-
age PWB.
Code Contents
Remarks
Causes Check procedures/corrective measures
No
Yes
OK?
No
Yes
Start
End.
"6010" error
shown?
Turn power switch off,then
on.
Check the installation
condition of the fuser
thermistor.
Replace the engine/high
voltage PWB.
Replace the engine/high
voltage PWB.
Remedy or replace the
fuser
thermistor.
See page P.1-5-14.
See page P.1-5-14.