8
Parallel Interface Connection
1 Plug one end of the printer cable (not
included) into the parallel interface con-
nector on the rear of the printer.
• Use a parallel printer cable
that complies with the
IEEE1284 standards.
• The printer will work best if it
is installed near the computer.
The connecting cable should
be shielded and not be longer
than 3 meters (10 feet).
2 Close the clips on both sides to fix the
connector in place.
Plug the other end of the printer cable
into the computer’s Centronics paral-
lel interface connector.
USB (Universal Serial Bus) Interface Connection
1 Plug one end of the USB cable on the
rear of the printer.
•Use a cable that complies
with Revision 2.0 of USB stan-
dard (a rectangular Type A
plug and a square Type B
plug).
• The connecting cable should
be shielded and not be longer
than 5 meters (16 feet).
2 Plug the other end of the USB cable into
the computer’s USB interface connec-
tor.
To p ri n te r
Clips
Printer Cable
To p r i nt e r
USB Cable
Ifs1020ep-eng.book 8 ページ ２００３年９月３日 水曜日 午後４時４７分
To Next Page
Loading...
