17
Printing a Status Page
To test the printer, print a status page indicating factory settings.
1 Turn on the printer’s power switch.
Upon turning on the power, the
printer’s 4 indicators flash in sequence
until printer initialization is complete,
then the indicator ( [on line]) lights
steadily.
If the indicator does not light,
check that previous steps were
performed properly.
If you install the toner container and
turn on the power, after a moment the
indicators light in sequence from top to
bottom. When the printer is first
switched on after toner installa-
tion, there will be a delay of
approximately 15 minutes before
the printer gets ready to print.
Once the indicator lights, printer
installation is complete.
2 The printer can print two different
types of status page — standard and
service-purpose. A service-purpose sta-
tus page contains more detailed infor-
mation about printer settings than a
standard status page.
• To print a standard status page, press
the key for at least 3 seconds and
the indicators light in sequence from
top to bottom.
• To print a service-purpose status
page, press the key for more than
10 seconds and the indicators light in
sequence twice from top to bottom.
If the status page prints correctly,
printer setup is complete. For details
on using the printer, refer to the Oper-
ation Guide contained as an electronic
file in the CD-ROM supplied with the
printer.
STEP
7
Ifs1020ep-eng.book 17 ページ ２００３年９月３日 水曜日 午後４時４７分
To Next Page
Loading...
