15
Multi-Purpose (MP) tray
1 Pull the MP tray towards you until it
stops.
2 Pull out the subtray and unfold the flap.
3 Adjust the position of the paper guides
on the MP tray. Standard paper sizes
are attached to the MP tray. For stan-
dard paper sizes, slide the guides to the
position marked correspondingly.
• Do not load more paper than
will fit under the load limits on
the inside of the MP tray.
• If the paper is considerably
curled in one direction, for
example, if the paper is
already printed on one side,
try to roll the paper in the
opposite direction to counter-
act the curl. Printed sheets
will then come out flat.
Subtray
Flap
Correct
Inco rrect
Ifs1020ep-eng.book 15 ページ ２００３年９月３日 水曜日 午後４時４７分
To Next Page
Loading...
