Troubleshooting 5-9
Error Indication
If the indicators light or flash repeatedly in manners not described
above for normal or maintenance indication, a service error has
probably occurred. Turn the printer off by the power switch, wait 5
seconds and then turn the printer on again. This may clear the error.
Even if the error is not cleared, contact your service technician.
The toner is running low. Have a new toner container ready.
The toner has run out. Replace with a new toner container.
After replacing the toner container,
clean the inside of the printer.
The installed toner container’s
regional specification does not
match the printer’s.
The manufacturer assumes no
liability for problems that occur
when toner container not
satisfying this requirement is used.
Install the specified toner container.
When you want to use the toner
container currently installed, press [GO]
and [Cancel] simultaneously for 3
second or more.
The current printing cannot be
continued.
Press [GO] to continue processing.
Press [Cancel] to cancel processing.
Unable to print as the data is too
complicated.
Press [GO] to continue processing.
Press [Cancel] to cancel processing.
Indicator Meaning Remedy
To Next Page
Loading...
