Kyocera FS-1118

Preparations
OPERATION GUIDE 3-7
Default Operation Mode
Use the following procedure to set the operation mode selected when the machine
is powered on. Modes available are Copy Operation, Send Operation or Status
Operation. It is recommended you select the most commonly used mode as the
default.
1 From System Menu/Counter press S or T to select Common Setting and
press Enter.
If you are unsure how to use this route map refer to Accessing Menu Items on
page 3-3.
2 Press S or T to select Default Operat and press Enter.
3 Press S or T to select the default operation mode from among Status, Copy
or Send.
4 Press Enter. The message display shows Completed and returns to Common
Setting.
5 Press right Select. The message display returns to the basic screen.
System Menu/
Counter
S or T
Common Setting
Enter
S or T
Default Operat
Enter