2JN
1-3-49
U603
Setting user data 1
Description
Makes user settings to enable the use of the machine as a fax.
Purpose
To be run after installation of the facsimile kit if necessary.
Method
1. Press the start key.
2. Select [LINE TYPE]. The current setting is displayed in reverse.
3. Select the setting using the cursor up/down keys.
Initial setting: DTMF
4. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U604
Setting user data 2
Description
Makes user settings to enable the use of the machine as a fax.
Purpose
Use this if the user wishes to adjust the number of rings that occur before the unit switches into fax receiving
mode when fax/telephone auto-select is enabled.
Method
1. Press the start key. The current setting is displayed.
2. Select [RINGS(F/P)#].
3. Change the setting using the cursor left/right keys or numeric keys.
If you set this to 0, the unit will start fax reception without any ringing.
4. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U605
Clearing data
Description
Initializes data related to the fax transmission such as transmission history.
Purpose
To clear the transmission history.
Method
1. Press the start key.
2. Select [CLEAR COM.REC.].
3. Press the start key. Initialization processing starts. When processing is finished, the screen for selecting
a maintenance item No. is displayed.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
DTMF DTMF
10PPS 10 PPS
20PPS 20 PPS
Description Setting range Initial setting
Number of fax/telephone rings 0 to 15 2 (120 V)/1 (220-240 V)
To Next Page
Loading...
