2JN-2
1-3-53
U620
Setting the remote switching mode
Description
Sets the signal detection method for remote switching. Be sure to change the setting according to the type of
telephone connected to the machine.
Method
1. Press the start key.
2. Select the setting using the cursor left/right keys.
Initial setting: ONE
3. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U625
Setting the transmission system 1
Description
Makes settings for the auto redialing interval and the number of times of auto redialing.
Purpose
Change the setting to prevent the following problems: fax transmission is not possible due to too short redial
interval, or fax transmission takes too much time to complete due to too long redial interval.
Start
1. Press the start key.
2. Select the item to be set.
Setting the auto redialing interval
1. Change the setting using the cursor left/right keys.
2. Press the start key. The value is set.
Setting the number of times of auto redialing
1. Change the setting using the cursor left/right keys or numeric keys.
When set to 0, no redialing is performed.
2. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
ONE One-shot detection
CONT Continuous detection
Display Description
INTERVAL Setting the auto redialing interval
TIMES Setting the number of times of auto redialing
Description Setting range Initial setting
Redialing interval 1 to 9 (min.) 3 (120 V)/2 (220-240 V)
Description Setting range Initial setting
Number of redialing 0 to 15 2 (120 V)/3 (220-240 V)
To Next Page
Loading...
