Kyocera FS-2100D - Page 259

8-15
Troubleshooting
An SD/SDHC Memory Card error has occurred. Look at the error code given in
place of ##.
The possible error codes and their descriptions are as follows.
02: The printer does not support the SD/SDHC memory card inserted, or the
SD/SDHC memory card is broken. Install the correct SD/SDHC memory card.
03: The SD/SDHC memory card is write protected using command operation.
Remove the write protection using the command.
04: There is not enough space in the SD/SDHC memory card. Delete
unnecessary files or use a new SD/SDHC memory card.
05: The desired file does not exist in the SD/SDHC memory card. Stored the file
in the SD/SDHC memory card.
10: The file stored in the SD/SDHC memory card is write protected using
command operation. Remove the write protection using the command.
An SSD error has occurred. Look at the error code given in place of ##.
The possible error codes and their descriptions are as follows.
03: The SSD is write protected using command operation. Remove the write
protection using the command.
04: There is no available SSD space. Delete unnecessary files, etc., in order to
free up space.
05: The desired file does not exist in the SSD. Stored the file in the SSD.
10: The file stored in the SSD is write protected using command operation.
Remove the write protection using the command.
Copying is not possible because data with the same file name exists at the
destination. Delete the data with the same file name at the destination before
copying.
The login user name entered is not registered. Check the login user name.
The account ID set has already been registered. Register a different account ID.
The changed login user name has already been registered. Set a different login
user name.
Message Corrective Action
SD card error.
Press [OK].
##
SSD error.
Press [OK].
##
The file name
already exists.
You cannot copy.
The user name is not
registered.
This account ID is
already registered.
This login user name
already registered.