Kyocera FS-2100D - Page 28

Preparation before Use
2-4
Checking that TCP/IP is On
This is an explanation of the method for setting for IPv4, but TCP/IP should also be On when setting for IPv6.
4 Select TCP/IP Settings and press [OK]. The TCP/IP Settings
menu screen appears.
5 Press U or V to select TCP/IP.
6 Press [OK]. The TCP/IP screen appears.
7 Check that On is selected. If Off is selected, then press U or V to
select On.
8 Press [OK]. The TCP/IP setting is set and the TCP/IP Settings
menu reappears.
Switching DHCP to Off or On
Select On when using a DHCP server to automatically obtain an IP Address. Select Off to enter an IP Address.
9 Press U or V to select IPv4 Setting.
10 Press [OK]. The IPv4 Setting menu screen appears.
11 Press U or V to select DHCP.
12 Press [OK]. The DHCP screen appears.
13 Press U or V to select Off or On.
Note "*" is displayed for the setting which has been
selected.
TCP/IP Settings: a b
********************-
2 IPv4 Setting
3 IPv6 Setting
[ Exit ]
1 TCP/IP
TCP/IP: a b
1 Off
********************-
2 *On
TCP/IP Settings: a b
********************-
2 IPv4 Setting
3 IPv6 Setting
[ Exit ]
1 TCP/IP
IPv4 Setting: a b
********************-
2 Auto-IP
3 IP Address
[ Exit ]
1 DHCP
DHCP: a b
1 Off
********************-
2 *On